Electro Guard Watch Remote Detection System / Wireless Doorbell - S-MDC-0378

Electro guard watch the remote detection system

1) Place the correct batteries in the detector & in the receiver units

2) Make sure that the batteries have been put in the proper positions

3) Mount the detector properly by the front door, window frame, driveway, walk path, backyard or anywhere you need.

4) Then switch on the receiver and adjust the volume to either hi or lo position

5) Now the remote detective system is operating with the infrared detect techonlogy

6) Place the receiver in an easy to reach place

7) When the detecer senses motion, the receiver will make an audible sound & the LED light will flash

8) Please wait for 30 seconds after switching on detective & receiver to activate

9) Please install both units 3 feet above ground level for optimal performance

10) Wireless Detector size: 89.52x62.02x48.5cm

11) Receiver size: 92.19x67.5x37.46cm

12) Wireless Detector / Outdoor:

Requires 9V heavy duty battery.

Infrared motion detection reaches maximum 400ft. Obstacles in fornt may shorten and narrow the coverage

Switch insidei unit for ON / OFF must switch on after installing batteries

13) Receiver / Indoor:

Requires 2xAA batteries

HI/LO switch for adjusting volume

Mounting bracket on back

When signals received, LCD indicator will flash & a built in speaker will give out beeping sound