Thermal insulation interface agent - YY-711

YUNYAN INTERFACE AGENT

YY-711

It enhances the performance and adhesion with mortar and base plane.Through this product, it can make the base surface becomes rough, so it can enhance cohesive force that effectively avoid the plaster layer hollowing, shrinkage cracking problems.

1)It is convenient and environmental.

2)It is non-toxic and harmless, non-corrosive flammable materials.

3)With super bonding force, excellent water resistance, aging resistance.

4)The ready-mix product, it can be used by adding water and latex after opening.

1. It is suitable for all inorganic surface of outside the buildings, including plaster mortar, precast concrete, gypsum board, standard brick, and brick wall, etc.

1.The base place should be smooth and strong, no dust, grease, release agents and batik materials, etc.

2.If the base plane is very uneven, leveling it with powder putty for exterior wall for one time.

3.The new plastered cement mortar surface should be maintained for more than 14 days before construction.

4.If the weather is too dry and hot, or the porosity of base plane is high, water the base plane and start construction after no clear water.

1.Mixing ratio: power: water= 25: (5~6)

2.Mix the interfacial agent in the proportion, stir with motor stirrer until even, standing for 5-10 minutes, and stir again will get better result.

3.Operate by brush or spray coating tool, scrape by trowel knife.

1.The product is suitable for construction in the 5-40°C.

2.If adding too much water when stirring, should add more powders.

3.The mortar should be used within 4 hours.

1.Keep in cold and dry place, unopened powder is valid for 1 year.

Spec

25kg/bag