Polyacrylonitrile Fiber

1. Part Name

Product Name:EEPolyacrylonitrile Fiber

2. Description:

EEPolyacrylonitrile Fiberis a new kind of synthetic reinforcement fiber for concrete. It is made of polyarylonitrile resins by special technique. It can improve the reinforcement of concrete and prevent crack

3. Physical parameters

4. Applicants

• The road, surface of road, bridge floor, runway and floor of the factory.
• Port, deepwater wharf, project in the severe cold area.
• Anti-collision wall of highway, anti-impact board;
• Reservoir, swimming pool;
• Side wall and roof of the basement

5. Advantages

For cement concrete:

• Increase the crack resistance of concrete;
• Increase the frost resistance and seepage resistance of concrete;
• Decrease the fragility of high strength concrete;
• Increase the wear resistance, tensile strength and toughness of concrete;
• Increase the impact resistance of concrete;
• Increase the durability of concrete;

Forbitulith:

• Increase the dispersion ability of asphalt concrete;
• Reinforcement of asphalt concrete;
• Increase the stability of asphalt concrete;
• Improve the toughness and frost resistance of bitulith;
• Improve the anti-skidding and wear-resisting ability.

6. Usage:

5-9kg/m³

7. Packaging

0.8-1.0kg degradable bags & Soluble wrapped pucks in 5 or 10kg cartons.

8. Working instructions

1). Mix amount: 0.9kg/m³ polyacrylonitrile fiber for cement concrete or 1.5-1.8kg/m³ polyacrylonitrile fiber for bridge floor with high requirement of anti-impact.

2). Stirring requirement: It is no need to change the proportion of cement, sand and aggregate.

For cement concrete: crushed stones, fibers, cement and sand are put into the blender and stir for 30 seconds, then put water and stir for 1 minute.

For asphalt concrete:Put crushed stones, sand and fibers into the blender and stir for 20 seconds. Then put the asphalt and stir up. The total time of stirring is not less than 60 seconds.

*The information contained in this document is given in good faith and by way of information at the time of printing. As the potential uses of our products are many and outside our control, each user is responsible for asking us for information on planned applications, as we cannot be held liable on the basis of general information. The buyer is required to monitor and respect, in his sole liability, the conditions under which our products are stored and used in his territory, to provide all required information to the user, and to respect all existing patents and all regulations applicable to our products and to his activity.

East Excellence Material (Asia) Co., Ltd

Tel: 00852-65170556

Fax: 00852-35902333

Add: Unit 04, 7/F, bright way tower, No. 33 Mong Kok road, Kowlong, HK.

Website: http://www.eastexcellence.com