230V Wood Pellet Fireplace Igniter/Innovacera - INC910

Our ceramic heating elements consist of Al2O3 insulation ceramics with an integrated Mo-Mn conductor,and reach a permanent operation temperature of between 900°C and 1100°C.

They are deployed in the following areas

1.Heating applications above 750°C,in which standard heating cartridges would have long since failed.

2.Very precise,rapid heating due to the extremely low thermal mass

3.Efficient hot gas generation through the extremely large heat transfer surface area.

Concrete applications:

-Hot surface igniters(ignition of gas,oil ,biomass,pellets)

-Hot air generation

-Tool heating

-Melting/Welting/Soldering/Hot air soldering

-Heaters for chemical analysis and laboratory equipment(eg:min-furnaces,reactors)

-Customer-specific heating solutions

Alumina Ceramic Igniter

Ceramic Igniters For Solid Fuel Furnaces

Our special application area for the high-temperature heaters is in heating systems that use solid fuels such as wood pellets as the energy source.The challenge here is to ignite the biomass in a very short time while retaining very low emission values .This can only be achieved with a sufficiently high ignition temperature.

Our short surface igniters are perfectly suited for this purpose.The special geometry of the cylindrical ceramic heaters,in conbination with an extremely high surface temperature of 1000°C,heats up the supply air in the shortest possible time to an extremely high temperature.After a maximum of 90 seconds,the fuel is ignited with a fraction of the energy that is required for a hot aire of ignition blower.This works,of course,not only with pellets,but also with wood chips,firewood,coal bricks or other solid fuels made of biomass.Further product advantages:

1.Ready assembled,easy-to-install systems

2.Space-saving,noiseless and impervious to overheating (in case the blower fails)

3.Extremely long-lasting and resilient

4.Minimal energy consumption

5.Completely electrically insulated

6.No exposed electrical contacts

7.No sensitive welding points

Ceramic hot surface igniters for pellet boilers need only approx.1/10 of the energyof that needed by hot air fans and ignition blowers. Their ignition capacity lies between 120 and 200 Watt. Depending on the positioning of the ignition element in the boiler, the ignition time of approx. 60 seconds is extremely short. This also means minimal emissions!

Not without reason,the high temperature heating elements pellet igniter is the reliable standard ignition system for pellet heating systems in Europe-hundreds of satisfied customers speak for themselves.

Production Technology----High Temperature Co Fired Ceramics (HTCC)

HTCC is an acronym for High-temperature co-fired ceramics; HTCC ceramic heating element is made up of high melting point metal heating material such as tungsten, molybdenum or molybdenum – manganese and 92-96% alumina ceramic substrates. The metal heating resistance slurry is printed onto the tape casting ceramic green body according to the design requirement, several layers of ceramic green body are then laminated together and is fired at 1500 ~ 1600 °C high temperature, with the aid of 4-8% sintering additive, to form the alumina ceramic heating element.

More Details,please contact CHARLIN(AT)INNOVACERA(DOT)COM